Blackss05
April 18th, 2007, 10:46pm
Ok so i used to work at Chevy and i had a tech print me out the how to on the tranny fluid change i will be hand typing what he printed so if there are any question feel free to PM me.
1. Remove the left front wheel
2. Raise and suitably support the vehicle.
3. Clean away all dirt and debris from the transmission fluid drain plug area. I would reccomend the use of brake cleaner but a rag could also be used.
4. Remove the drain plug which is located on the bottom of the transmission.
5. Let the transmission drain out all the fluid.
6. Reinstall the drain plug and tighten to 28 lb ft.
7. Remove the level check plug which is located a little bit above the drain plug.
8. Fill the transmission with the proper fluid until eve with the bottom ofthe fill plug hole.
9. Install the level check plug and tighten to 28 lb ft.
10 Reinstall the left front wheel and feel free to start the car.
One suggestion would be that after starting let the car idle for 2-5 minutes before driving. Also never check the fluid when the transmission is hot always do this cold.
1. Remove the left front wheel
2. Raise and suitably support the vehicle.
3. Clean away all dirt and debris from the transmission fluid drain plug area. I would reccomend the use of brake cleaner but a rag could also be used.
4. Remove the drain plug which is located on the bottom of the transmission.
5. Let the transmission drain out all the fluid.
6. Reinstall the drain plug and tighten to 28 lb ft.
7. Remove the level check plug which is located a little bit above the drain plug.
8. Fill the transmission with the proper fluid until eve with the bottom ofthe fill plug hole.
9. Install the level check plug and tighten to 28 lb ft.
10 Reinstall the left front wheel and feel free to start the car.
One suggestion would be that after starting let the car idle for 2-5 minutes before driving. Also never check the fluid when the transmission is hot always do this cold.